Prior to purchasing Magic Interlacer Pro 100 with FlashBand Generator,
you must download the Full Working Version first (Click "Try"
button above). These programs will run on only one computer and
require a "Hardware-Fingerprint" number in order to operate.
Once you have installed the programs and run either program, you
will be presented with a Reminder screen. In this screen is your
"Hardware-Fingerprint" number. Write this number down.
You will need it when you purchase the software.
"Reminder" will not be seen if you have purchased the
program and entered your "key".)
Click on the "Buy" button (above) or on the "Reminder"
screen from the program. After selecting the software and going
to check-out, you will be presented with an "information entry
screen". This is where you will need the "Hardware-Fingerprint"
you're ready to purchase Magic Interlacer Pro 100 with FlashBand
Generator, add it to your shopping cart and proceed to "checkout".
Complete your personal information and submit the order form. You
will then be contacted by ProMagic to confirm payment.
approved, you will receive your "Key" via email. Start
the program and select "Enter Key" button.
Enter your name and "Key". Click OK. You will get one
more screen telling you that your "key" is valid. That's
all there is to it!